Hardware, Mounting, Frames, Stars, Oakleaf, Numbers, Letters, Crosses, Shooting Award Bars, etc.

Air Force size frame that goes on service style ribbons. Gold or silver finish. Size is 7/16" tall by 1-7/16" wide. Army size also available which is 5/8" tall and 1-15/32 wide, gold finish, SILVER LIMITED AVAILABILITY approximately 60 each size in stock.

Single Ribbon mounting bar with butterfly clutches for cloth style ribbons.

Double Ribbon Mounting Bar, two across, with butterfly clutches, for cloth style ribbons.

Triple ribbon bar, 3 across, brass with butterfly clutches, for cloth style ribbons.

Star ribbon device attachment for service style ribbon with two prongs on back. 3/16" size in blue, silver, gold, bronze, red, green....any color you need can be made.

2 on mount ribbon device, ease of application using only one set of prongs.

3 stars mounted on one set of prongs for ease of application. Choice of finish regular silver, gold, bronze, painted blue or other (note in description of order).

Also available in multiples of 2, 3 and 4 on one backing.

2 on, mounted oakleaf on one set of prongs for ease of application. Choice of finish, silver, gold, bronze.

3 on, mounted oakleaf on one set of prongs for ease of application. Choice of finish, silver, gold, bronze, other (specify in comments section of order form).

4 on, mounted oakleaf on one set of prongs for ease of application. Choice of finish, silver, gold, bronze.

Singles of A-Z 1/4" tall "V" wire on back

Cross ribbon device. Can be ordered in silver, gold, red, or any custom color (add'l fee). This item has two prongs to push through your cloth ribbon and spread open in back for secure. If you require a custom color, please specify the color in the remarks section of the order form. Add'l flat fee of $2.00.

This Maltese Cross is 3/16" with prongs on the back for use on cloth ribbons. These are mfg. in BRONZE. Gold or Silver options are Painted, they are not mfg. in these finishes.

Sample of our shooting award bar for cloth ribbons, you may have them alone or mounted on your choice of ribbon. They come in 4 finishes and can be engraved to your specs keeping size in mind.

Brass Butterfly Clutches

It's come to our attention that the military/ball clutch nametag holder is SO good that it's pulling the back right off the tag. Of course this is not acceptable and should not happen but there is a way to use this clutch that should prevent that. The top of the clutch has a little thumbscrew that tightens/loosens (righty tighty/lefty loosy) the mechanism. When removing, press down and loosen pulling steadily upward while holding onto the plate. When putting on, loosen or tighten before putting on the post, if it's too tight, it won't go down, if it's too loose, it will come off easily. CALL WITH ANY QUESTIONS!

Cap nut for screwback style nametag.

Secure your hatshield to your uniform hat, thumb syle screw nut, brass. Pictured: front, back and side view. These are slightly different than in past, but work just the same.

Two finishes, Bronze and Silver. These have 2 prongs on back that go through your cloth ribbons.

Two-On Diamond Ribbon Attachment, Bronze Only

Diamond Ribbon Attachment Three Across

Diamond Ribbon Attachment Four Across

Used for Honor, Honor Guard, your designation.

Comes in pairs.

pin to fit into cloth commendation bar

Folded Flag ribbon attachment